This is a great little project to use up some of your fabric scraps. These coasters are placed together in squares, then cut into circles. It’s great practice of sewing along curves too! I definitely plan to make more as I accumulate more scraps. This was my first time doing any kind of quilting, and I have to say, it was quite gratifying. Maybe I’ll take on a little bigger quilting something or other…. Any suggestions for smaller quilting projects? I’d love to see!
Here’s what you will need to do for four coasters.
Cut 24 3×3 squares out of your fabric. Lay out the squares to decide what order you want them: There will be four used in each coaster. Begin with two squares and sew them together, right sides facing, to form one piece Press open the seam. Sew two more squares together, and press open the seam. Next, pin the two joined pieces together, right sides facing and the seams aligned. Sew together, to form the coaster top. Press open the seam. Repeat to make three more coaster tops.
Place one coaster top, right-side up, on a fusible fleece circle, wrong side facing the fusible (textured) side of the fleece circle. Using a hot iron, fuse the fabric to the fleece. Repeat with the remaining three coaster tops and three fleece circles.
lines (see figure C). Repeat with the other three remaining coaster tops.
Sew backing to quilted top piece. With a backing fabric piece and a quilted top piece together, right sides facing, sew around the edge with a 1/4-in, leaving a 1½-in opening to turn the coaster right-side out. Or you can just sew along the line that you drew in the step* above. Be sure to backstitch at the beginning and end of your stitches. Repeat with the other three coasters.
Close and topstitch. Turn one coaster right-side out by pulling it gently through the opening. Push out the inner seam so it makes a smooth circular shape. Turn the fabric under at the opening by ¼ in and press flat and pin if necessary. Topstitch around the edge of the coaster, about 1/8 in from the edge, sewing the opening closed and flattening the edges. Repeat to finish the other three coasters.
Original source found here.